Call line opening soon

Pike County, Illinois · Pittsfield

Water damage restoration in Pike County, Illinois

Water spreading, a burst pipe, sewage, mold or smoke? Call to be connected with a restoration company that serves Pittsfield, Barry and Griggsville. Start the steps below while you wait.

Answered 24/7 by a participating local provider. We're a referral service and don't do the work ourselves. How it works

Start here

What's happening?

Pick the closest match. These steps limit the damage and protect your insurance claim. Skip anything that isn't safe.

Burst or frozen pipe: what to do in your Pike County home right now

Pike County averages 33 nights a year at 20°F or colder, mostly November to February, and 49% of its homes predate 1960.

  1. Shut off the main water valve.
  2. Open the lowest faucet in the house.
  3. Turn off the water heater.

Full step-by-step guide

Flooded basement: what to do in your Pike County home right now

Heavy rain days of an inch or more come about 8.8 times a year here, most often in July. A sump pump that hasn't run since last season is a common weak point.

  1. Don't step in if water could reach outlets, cords, or the electrical panel.
  2. Check the sump pump.
  3. Note where the water came in.

Full step-by-step guide

Sewage or toilet backup: what to do in your Pike County home right now

Backups often follow heavy rain, which Pike County gets about 8.8 days a year, when storm water overloads sewer mains and pushes up through the lowest drain in the house.

  1. Treat it as contaminated (Category 3) water.
  2. Stop using every drain, toilet, and appliance that drains.
  3. Don't try to clean carpet, padding, or upholstery that sewage touched.

Full step-by-step guide

Roof leak or storm: what to do in your Pike County home right now

Roof leaks here come from summer downpours and, with about 77 freeze-thaw days a year, from winter ice dams. Most show up as ceiling stains in the room below.

  1. Stay off the roof during the storm.
  2. Catch the water and protect the floor.
  3. Watch for a sagging ceiling.

Full step-by-step guide

Fire or smoke: what to do in your Pike County home right now

15% of occupied homes in Pike County heat mainly with wood or propane, below the Illinois county median of 16.5%.

  1. Don't go back in until the fire department says it's safe.
  2. Don't run the furnace or central air.
  3. Don't wipe soot off walls or furniture.

Full step-by-step guide

Mold or musty smell: what to do in your Pike County home right now

Muggy summer nights, lows of 65°F or more, come about 59 times a year in Pike County. Mold after a leak spreads fastest from June through August.

  1. Find and stop the moisture first.
  2. Don't disturb large patches.
  3. Small spots can be a DIY job.

Full step-by-step guide

Local risk profile

Why homes in Pike County get water damage

About 14,469 people live in Pike County, 831 square miles in western Illinois, in roughly 7,273 homes. The county seat is Pittsfield, and Barry, Griggsville and Pleasant Hill round out the largest towns. The county's median home was built in 1961.

62/100 Water Damage Risk Index: Elevated Pike County ranks 14 of 102 Illinois counties. See the statewide ranking and method.
1

Aging plumbing

49% of homes built before 1960

Spotting hidden leaks →
2

Leaks in empty homes

18% of homes vacant

Shutoffs and leak sensors →
3

Muggy, mold-friendly summers

59 nights a year at 65°F or warmer

Mold after water damage →

The three factors where Pike County ranks highest compared with other Illinois counties.

Weather

For frozen pipes, Pike County is a typical Illinois county, which is still plenty. In the 2015–2024 record the county logged about 33 nights a year at or below 20°F (55th of 102) and 101 below freezing. Twenty degrees is roughly where uninsulated pipes start to freeze.

On January 15, 2024 the low fell to about -12°F, and in the stretch ending February 2021 the county went 15 days in a row below freezing. Leaks from split pipes typically appear the day the thaw arrives.

Expect the hardest freezes in January, inside a season that runs November to February. That's when an outdoor spigot left connected to a hose, or a pipe in a crawl space, is most likely to split.

On average the first fall freeze arrives around Oct 29 and the last spring freeze around Apr 13.

Rainfall is about average for Illinois. The county gets about 39.6 inches of rain and melted snow a year, with 8.8 days of an inch or more (44th of 102). Those downpours cluster in May, June and July, when sump pumps and gutters are tested hardest. The wettest day on record brought 3.52 inches on April 30, 2017. Multi-day storms matter most for basements; the wettest three days on record here totaled 4.88 inches (through May 1, 2017).

Freeze-thaw days, below freezing overnight and above it by afternoon, come about 77 times a year here. They're the main driver of ice dams and of water working its way through foundation cracks in late winter.

26
Freezing nights per month, 2015–2024 average
1.6
Days with 1 inch or more of rain per month, 2015–2024 average

Housing

What Pike County's homes are made of

Illinois's 102 counties range widely in housing age; Pike ranks 18th, with 76% of its homes built before 1980.

Before 1960 is when 49% of these homes went up. Galvanized supply lines and cast iron drains were standard then, and after 60-plus years both corrode and crack, often out of sight inside a wall or under a slab.

Manufactured and mobile homes make up 8% of the housing here. Water lines in the underbelly depend on intact skirting and working heat tape, and they're usually the first to freeze in a cold snap.

18% of homes were vacant at survey time. A leak in an empty rental or seasonal house can run for days before anyone notices, which is why those losses tend to be larger.

Homes by year built

  • Before 194030%
  • 1940–195919%
  • 1960–197927%
  • 1980–199913%
  • 2000 or later11%
Owner-occupied
78%
Illinois median 77%
Single-family
84%
of all homes
Median home value
$101k
Illinois median $135k

Beyond water

Mold and fire damage in Pike County

Mold

Summer nights that don't drop below 65°F, a good marker of humid air, come about 59 times a year here, above the Illinois county median of 51. The EPA recommends keeping indoor humidity below 60%, ideally 30 to 50%. Basements can pass 60% on their own in summer, so a dehumidifier matters even without a leak, and anything wet should be dried within 24 to 48 hours.

Mold remediation: what to expect

Fire and smoke

Main heating fuel in Pike County's occupied homes: 52% utility gas, 33% electric, 13% propane and 2% wood. Heating equipment, cooking and electrical failures cause most home fires nationally. Even a small kitchen fire can leave soot through the whole house, because smoke follows air currents into closets, ducts and attic space.

Fire and smoke cleanup: first steps

Coverage

Communities served

Calls connect to restoration companies that work across Pike County. The largest communities by population:

  • Pittsfield4,420
  • Barry1,512
  • Griggsville1,310
  • Pleasant Hill970
  • Hull413
  • Nebo266
  • Kinderhook249
  • New Canton230
  • Milton217
  • Perry206
  • El Dara118
  • Baylis102

Population from ACS 2020-2024 5-year estimates. Townships and unincorporated areas are covered too.

Nearby

Neighboring counties

Adams, Brown, Morgan and Scott get more pipe-freeze nights than Pike. Greene County has the oldest housing nearby, with 76% of homes built before 1980.

By the numbers

Pike County compared with Illinois

FactorPikeIllinois medianRank
Homes built before 1960 49% 38% 18 of 102
Homes built before 1980 76% 66% 18 of 102
Homes built 2000 or later 11% 15% 74 of 102
Manufactured or mobile homes 8% 5.6% 39 of 102
Vacant homes 18% 11% 14 of 102
Wood or propane heat 15% 17% 61 of 102
Nights at 20°F or colder 33/yr 35/yr 55 of 102
Days with 1 inch+ of rain 8.8/yr 8.4/yr 44 of 102
Freeze-thaw days 77/yr 81/yr 61 of 102
Muggy nights (65°F+) 59/yr 51/yr 37 of 102

Rank 1 is the highest value. Bars run from the lowest to the highest Illinois county; the tick marks the median; orange means higher water damage risk than the median, green means lower.

Questions

Pike County water damage FAQ

Which towns in Pike County does this cover?
Calls are routed to restoration companies that serve all of Pike County, including Pittsfield, Barry, Griggsville, Pleasant Hill, Hull and Nebo, plus the townships and rural areas around them. If the first company can't reach you quickly, ask to be connected with another.
How often do pipes freeze in Pike County?
From 2015–2024 the county averaged 33 nights a year at 20°F or colder, mostly November to February. Pipes in exterior walls, crawl spaces, garages and mobile home underbellies freeze first.
What causes the most water damage in Pike County?
Based on the county's housing and weather data, the biggest local factors are aging plumbing, leaks in empty homes and muggy, mold-friendly summers. Appliance supply lines and water heaters cause leaks everywhere.
Will my insurance cover water damage in Pike County?
A burst pipe or a failed water heater is usually covered. Rain-driven basement water usually isn't, unless you added water backup coverage, and floodwater needs a flood policy. May, June and July are when Pike County gets the most heavy rain.
How fast does mold start in a Pike County home?
The EPA advises drying wet materials within 24 to 48 hours. In July, the county's wettest month, and on the 59 muggy summer nights a year when lows stay at 65°F or above, basements dry slowly on their own, so start fans and dehumidifiers the same day.

Water won't wait. Neither should you.

Peak risk months in Pike County: freezing from November to February, heavy rain in May, June and July.

Call line opening soon

Sources: U.S. Census Bureau, ACS 2024 5-year estimates (2020-2024); weather from NOAA nClimGrid-Daily county averages (EpiNOAA), 2015–2024, averaged across the county; county boundaries from Census TIGER. Reviewed 2026-10-21. Methodology

Opening soon Checklist