Call line opening soon

Victoria County, Texas · Victoria

Water damage restoration in Victoria County, Texas

Water spreading, a burst pipe, sewage, mold or smoke? Call to be connected with a restoration company that serves Victoria, Inez and Bloomington. Start the steps below while you wait.

Answered 24/7 by a participating local provider. We're a referral service and don't do the work ourselves. How it works

Start here

What's happening?

Pick the closest match. These steps limit the damage and protect your insurance claim. Skip anything that isn't safe.

Burst or frozen pipe: what to do in your Victoria County home right now

With 20% of homes built before 1960 and about 0 hard-freeze nights a year, frozen and split pipes are a leading winter risk in the county.

  1. Shut off the main water valve.
  2. Open the lowest faucet in the house.
  3. Turn off the water heater.

Full step-by-step guide

Flooded basement: what to do in your Victoria County home right now

May brings the most downpours to Victoria County, part of 8.5 heavy-rain days a year. Check the sump first.

  1. Don't step in if water could reach outlets, cords, or the electrical panel.
  2. Check the sump pump.
  3. Note where the water came in.

Full step-by-step guide

Sewage or toilet backup: what to do in your Victoria County home right now

Sewage backups in Victoria County spike on heavy-rain days, about 8.5 a year, when sewer mains fill up and water finds the lowest drain.

  1. Treat it as contaminated (Category 3) water.
  2. Stop using every drain, toilet, and appliance that drains.
  3. Don't try to clean carpet, padding, or upholstery that sewage touched.

Full step-by-step guide

Roof leak or storm: what to do in your Victoria County home right now

Victoria County's wettest day in the 2015–2024 record brought 7.74 inches.

  1. Stay off the roof during the storm.
  2. Catch the water and protect the floor.
  3. Watch for a sagging ceiling.

Full step-by-step guide

Fire or smoke: what to do in your Victoria County home right now

4% of occupied homes in Victoria County heat mainly with wood or propane, below the Texas county median of 6.5%.

  1. Don't go back in until the fire department says it's safe.
  2. Don't run the furnace or central air.
  3. Don't wipe soot off walls or furniture.

Full step-by-step guide

Mold or musty smell: what to do in your Victoria County home right now

Muggy summer nights, lows of 65°F or more, come about 187 times a year in Victoria County. Mold after a leak spreads fastest from June through August.

  1. Find and stop the moisture first.
  2. Don't disturb large patches.
  3. Small spots can be a DIY job.

Full step-by-step guide

Local risk profile

Why homes in Victoria County get water damage

Victoria County covers 882 square miles of southeast Texas, with about 91,413 residents and 39,481 homes. Besides Victoria, the county seat, the biggest communities are Inez, Bloomington and Quail Creek. The county's median home was built in 1983.

45/100 Water Damage Risk Index: Elevated Victoria County ranks 166 of 232 Texas counties. See the statewide ranking and method.
1

Muggy, mold-friendly summers

187 nights a year at 65°F or warmer

Mold after water damage →
2

Heavy rain and basements

8.5 days a year with an inch or more

Basement waterproofing →
3

Aging plumbing

20% of homes built before 1960

Spotting hidden leaks →

The three factors where Victoria County ranks highest compared with other Texas counties.

Weather

Victoria County is milder than most of Texas, but not mild enough to skip winterizing. From 2015–2024 it averaged 0 nights a year at 20°F or colder, the range where pipes in exterior walls, crawl spaces and unheated garages freeze, and 5 nights at or below 32°F. That ranks 205th of 232 counties.

With only about 5 freezing nights a year, many homes here aren't built for cold, so a single arctic outbreak can burst pipes across the county. The record low in this data was about 16°F, on February 16, 2021.

Rainfall is about average for Texas. Of roughly 37.6 inches of yearly precipitation, the damage comes from the 8.5 days a year with an inch or more, ranked 104th of 232. January, May and June see the most. The single wettest day in the record: 7.74 inches, August 26, 2017. Multi-day storms matter most for basements; the wettest three days on record here totaled 11.91 inches (through August 28, 2017).

3
Freezing nights per month, 2015–2024 average
1.4
Days with 1 inch or more of rain per month, 2015–2024 average

Housing

What Victoria County's homes are made of

47% of homes in Victoria County predate 1980, close to the Texas county median of 45.8%, which ranks 109th of Texas's 232 counties.

Older and newer homes sit side by side here: 20% predate 1960 and 27% are from 2000 or later. Corroded pipe is the typical failure in the first group, burst supply hoses in the second.

The 1980s and 1990s account for 26% of the county's homes. If yours is from those decades, look under the sinks and at the water heater for gray plastic pipe stamped PB, which is polybutylene and leak-prone.

Here 11% of housing is manufactured homes. Check the skirting and the heat tape on the main water line every fall, because that one exposed line is what freezes.

Renters occupy 35% of homes. If you rent, the building is usually the landlord's to repair, but your belongings are only covered by renters insurance.

Homes by year built

  • Before 19404%
  • 1940–195916%
  • 1960–197926%
  • 1980–199926%
  • 2000 or later27%
Owner-occupied
65%
Texas median 74%
Single-family
66%
of all homes
Median home value
$210k
Texas median $172k

Beyond water

Mold and fire damage in Victoria County

Mold

Victoria County averages 187 warm, muggy nights a year (lows of 65°F or more) and gets the most rain in June. Keep indoor humidity under 60%, as the EPA advises, and dry any leak within 24 to 48 hours; in a humid month a wet basement left alone won't dry by itself.

Mold remediation: what to expect

Fire and smoke

By main heating fuel, Victoria County homes break down as 26% utility gas, 68% electric, 3% propane and under 1% wood. Heating equipment, cooking and electrical failures cause most home fires nationally. Even a small kitchen fire can leave soot through the whole house, because smoke follows air currents into closets, ducts and attic space.

Fire and smoke cleanup: first steps

Coverage

Communities served

Calls connect to restoration companies that work across Victoria County. The largest communities by population:

  • Victoria65,625
  • Inez2,031
  • Bloomington1,895
  • Quail Creek1,715
  • Placedo539

Population from ACS 2020-2024 5-year estimates. Townships and unincorporated areas are covered too.

Nearby

Neighboring counties

DeWitt, Goliad and Lavaca get more pipe-freeze nights than Victoria. Refugio County has the oldest housing nearby, with 60% of homes built before 1980.

By the numbers

Victoria County compared with Texas

FactorVictoriaTexas medianRank
Homes built before 1960 20% 20% 111 of 232
Homes built before 1980 47% 46% 109 of 232
Homes built 2000 or later 27% 26% 109 of 232
Manufactured or mobile homes 11% 13% 152 of 232
Vacant homes 12% 17% 171 of 232
Wood or propane heat 3.5% 6.5% 181 of 232
Nights at 20°F or colder 0/yr 3/yr 205 of 232
Days with 1 inch+ of rain 8.5/yr 7.8/yr 104 of 232
Freeze-thaw days 5/yr 27/yr 206 of 232
Muggy nights (65°F+) 187/yr 129/yr 20 of 232

Rank 1 is the highest value. Bars run from the lowest to the highest Texas county; the tick marks the median; orange means higher water damage risk than the median, green means lower.

Questions

Victoria County water damage FAQ

Which towns in Victoria County does this cover?
Calls are routed to restoration companies that serve all of Victoria County, including Victoria, Inez, Bloomington, Quail Creek and Placedo, plus the townships and rural areas around them. If the first company can't reach you quickly, ask to be connected with another.
How often do pipes freeze in Victoria County?
Pipe-freeze weather, 20°F or colder, comes about 0 nights a year in Victoria County, from midwinter. Pipes along outside walls and in crawl spaces go first.
What causes the most water damage in Victoria County?
Based on the county's housing and weather data, the biggest local factors are muggy, mold-friendly summers, heavy rain and basements and aging plumbing. Appliance supply lines and water heaters cause leaks everywhere.
Will my insurance cover water damage in Victoria County?
A burst pipe or a failed water heater is usually covered. Rain-driven basement water usually isn't, unless you added water backup coverage, and floodwater needs a flood policy. January, May and June are when Victoria County gets the most heavy rain.
How fast does mold start in a Victoria County home?
The EPA advises drying wet materials within 24 to 48 hours. In June, the county's wettest month, and on the 187 muggy summer nights a year when lows stay at 65°F or above, basements dry slowly on their own, so start fans and dehumidifiers the same day.

Water won't wait. Neither should you.

Peak risk months in Victoria County: freezing from midwinter, heavy rain in January, May and June.

Call line opening soon

Sources: U.S. Census Bureau, ACS 2024 5-year estimates (2020-2024); weather from NOAA nClimGrid-Daily county averages (EpiNOAA), 2015–2024, averaged across the county; county boundaries from Census TIGER. Reviewed 2026-10-21. Methodology

Opening soon Checklist