Call line opening soon

Wilson County, Texas · Floresville

Water damage restoration in Wilson County, Texas

Water spreading, a burst pipe, sewage, mold or smoke? Call to be connected with a restoration company that serves Floresville, Poth and Stockdale. Start the steps below while you wait.

Answered 24/7 by a participating local provider. We're a referral service and don't do the work ourselves. How it works

Start here

What's happening?

Pick the closest match. These steps limit the damage and protect your insurance claim. Skip anything that isn't safe.

Burst or frozen pipe: what to do in your Wilson County home right now

Pipes freeze in Wilson County on about 1 night a year, mostly midwinter. Older homes, 6% of the stock here, are most at risk.

  1. Shut off the main water valve.
  2. Open the lowest faucet in the house.
  3. Turn off the water heater.

Full step-by-step guide

Flooded basement: what to do in your Wilson County home right now

Basements flood here mostly in May. Wilson County averages 8 days a year with an inch of rain or more.

  1. Don't step in if water could reach outlets, cords, or the electrical panel.
  2. Check the sump pump.
  3. Note where the water came in.

Full step-by-step guide

Sewage or toilet backup: what to do in your Wilson County home right now

Sewage backups in Wilson County spike on heavy-rain days, about 8 a year, when sewer mains fill up and water finds the lowest drain.

  1. Treat it as contaminated (Category 3) water.
  2. Stop using every drain, toilet, and appliance that drains.
  3. Don't try to clean carpet, padding, or upholstery that sewage touched.

Full step-by-step guide

Roof leak or storm: what to do in your Wilson County home right now

Roof leaks here come from summer downpours. Most show up as ceiling stains in the room below.

  1. Stay off the roof during the storm.
  2. Catch the water and protect the floor.
  3. Watch for a sagging ceiling.

Full step-by-step guide

Fire or smoke: what to do in your Wilson County home right now

7% of occupied homes in Wilson County heat mainly with wood or propane, close to the Texas county median of 6.5%.

  1. Don't go back in until the fire department says it's safe.
  2. Don't run the furnace or central air.
  3. Don't wipe soot off walls or furniture.

Full step-by-step guide

Mold or musty smell: what to do in your Wilson County home right now

About 168 nights a year here stay at 65°F or warmer, so basements and crawl spaces can grow mold even without a leak.

  1. Find and stop the moisture first.
  2. Don't disturb large patches.
  3. Small spots can be a DIY job.

Full step-by-step guide

Local risk profile

Why homes in Wilson County get water damage

Wilson County covers 804 square miles of southern Texas, with about 52,781 residents and 19,480 homes. Floresville is the county seat; Poth, Stockdale and La Vernia are the next largest communities. Much of its housing is recent, with a median build year of 2000.

33/100 Water Damage Risk Index: Moderate Wilson County ranks 222 of 232 Texas counties. See the statewide ranking and method.
1

Muggy, mold-friendly summers

168 nights a year at 65°F or warmer

Mold after water damage →
2

Mobile home freeze-ups

26% manufactured homes

Keeping lines from freezing →
3

Heavy rain and basements

8 days a year with an inch or more

Basement waterproofing →

The three factors where Wilson County ranks highest compared with other Texas counties.

Weather

Winters here are on the gentler end for Texas, and pipes still freeze. In the 2015–2024 record the county logged about 1 night a year at or below 20°F (159th of 232) and 9 below freezing. Twenty degrees is roughly where uninsulated pipes start to freeze.

On February 15, 2021 the low fell to about 13°F, and in the stretch ending February 2021 the county went 3 days in a row below freezing. Leaks from split pipes typically appear the day the thaw arrives.

Hard freezes are uncommon here, about 9 nights a year at or below 32°F, and that's exactly why they do damage: pipes in attics, exterior walls and slab-edge plumbing are rarely insulated. The coldest night in the record was about 13°F on February 15, 2021.

Rainfall is about average for Texas. About 8 days a year bring an inch or more (110th of 232), most often in May, out of 30.7 inches of total precipitation. On August 27, 2017, 4.08 inches fell in a single day. The worst three-day stretch dropped 7.48 inches, ending August 28, 2017, the kind of soaking that overwhelms sump pumps and storm sewers.

4
Freezing nights per month, 2015–2024 average
1.4
Days with 1 inch or more of rain per month, 2015–2024 average

Housing

What Wilson County's homes are made of

Texas's 232 counties range widely in housing age; Wilson ranks 225th, with 17% of its homes built before 1980.

49% of homes were built in 2000 or later, more than in most of Texas. Newer plumbing rarely corrodes, so damage here tends to come from appliance supply lines, water heaters, sump pumps and storms.

About 34% of homes went up between 1980 and 1999. Some houses from the late 1970s to the mid-1990s were plumbed with polybutylene, a gray plastic pipe known for failing at fittings. A plumber can tell you in a few minutes whether you have it.

Here 26% of housing is manufactured homes. Check the skirting and the heat tape on the main water line every fall, because that one exposed line is what freezes.

Homes by year built

  • Before 19402%
  • 1940–19594%
  • 1960–197911%
  • 1980–199934%
  • 2000 or later49%
Owner-occupied
85%
Texas median 74%
Single-family
68%
of all homes
Median home value
$321k
Texas median $172k

Beyond water

Mold and fire damage in Wilson County

Mold

Wilson County averages 168 warm, muggy nights a year (lows of 65°F or more) and gets the most rain in May. Keep indoor humidity under 60%, as the EPA advises, and dry any leak within 24 to 48 hours; in a humid month a wet basement left alone won't dry by itself.

Mold remediation: what to expect

Fire and smoke

Heating fuel matters for fire risk. In Wilson County it's 7% utility gas, 85% electric, 6% propane and under 1% wood. Fires here are likelier to start in the kitchen or the wiring than in the furnace. After any fire, keep the HVAC off until ducts are checked, or soot will travel through the house.

Fire and smoke cleanup: first steps

Coverage

Communities served

Calls connect to restoration companies that work across Wilson County. The largest communities by population:

  • Floresville8,007
  • Poth1,532
  • Stockdale1,377
  • La Vernia1,095

Population from ACS 2020-2024 5-year estimates. Townships and unincorporated areas are covered too.

Nearby

Neighboring counties

Wilson gets more pipe-freeze nights than any of its neighbors. Gonzales County has the oldest housing nearby, with 46% of homes built before 1980.

By the numbers

Wilson County compared with Texas

FactorWilsonTexas medianRank
Homes built before 1960 5.9% 20% 219 of 232
Homes built before 1980 17% 46% 225 of 232
Homes built 2000 or later 49% 26% 15 of 232
Manufactured or mobile homes 26% 13% 17 of 232
Vacant homes 6.6% 17% 218 of 232
Wood or propane heat 7% 6.5% 111 of 232
Nights at 20°F or colder 1/yr 3/yr 159 of 232
Days with 1 inch+ of rain 8/yr 7.8/yr 110 of 232
Freeze-thaw days 9/yr 27/yr 186 of 232
Muggy nights (65°F+) 168/yr 129/yr 41 of 232

Rank 1 is the highest value. Bars run from the lowest to the highest Texas county; the tick marks the median; orange means higher water damage risk than the median, green means lower.

Questions

Wilson County water damage FAQ

Which towns in Wilson County does this cover?
Calls are routed to restoration companies that serve all of Wilson County, including Floresville, Poth, Stockdale and La Vernia, plus the townships and rural areas around them. If the first company can't reach you quickly, ask to be connected with another.
How often do pipes freeze in Wilson County?
Pipe-freeze weather, 20°F or colder, comes about 1 night a year in Wilson County, from midwinter. Pipes along outside walls and in crawl spaces go first.
What causes the most water damage in Wilson County?
Based on the county's housing and weather data, the biggest local factors are muggy, mold-friendly summers, mobile home freeze-ups and heavy rain and basements. Appliance supply lines and water heaters cause leaks everywhere.
Will my insurance cover water damage in Wilson County?
Pipe bursts and appliance failures are typically covered; slow leaks, seepage and floodwater typically aren't. Ask your agent about water backup coverage, given 8 heavy-rain days a year here.
How fast does mold start in a Wilson County home?
The EPA advises drying wet materials within 24 to 48 hours. In May, the county's wettest month, and on the 168 muggy summer nights a year when lows stay at 65°F or above, basements dry slowly on their own, so start fans and dehumidifiers the same day.

Water won't wait. Neither should you.

Peak risk months in Wilson County: freezing from midwinter, heavy rain in April, May and September.

Call line opening soon

Sources: U.S. Census Bureau, ACS 2024 5-year estimates (2020-2024); weather from NOAA nClimGrid-Daily county averages (EpiNOAA), 2015–2024, averaged across the county; county boundaries from Census TIGER. Reviewed 2026-10-21. Methodology

Opening soon Checklist